欢迎访问《现代矿业》杂志官方网站,今天是 分享到:
×

扫码分享

现代矿业 ›› 2022, Vol. 38 ›› Issue (07): 201-.

• 材料·装备 • 上一篇    下一篇

某矿全尾砂膏体充填自流输送可靠性分析

曾文旭1,2 李鹏程1,2   

  1. 1. 中钢集团马鞍山矿山研究总院股份有限公司;2. 金属矿山安全与健康国家重点实验室
  • 出版日期:2022-07-25 发布日期:2023-06-09

Reliability Analysis of Gravity Conveying of Full Tailings Paste Filling in a Mine

ZENG Wenxu1,2 LI Pengcheng1,2   

  1. 1. Sinosteel Maanshan General Institute of Mining Research Co.,Ltd.; 2. State Key Laboratory of Metal Mine Safety and Health
  • Online:2022-07-25 Published:2023-06-09

摘要: 为探究某矿全尾砂充填料浆的管道自流输送可靠性,对各配比全尾砂充填料浆的塌 落度、稠度、分层度、屈服应力及塑性黏度进行了测试,对当前充填系统条件下所推荐配比全尾砂 料浆的临界流速和充填倍线进行了计算。结果表明,料浆质量浓度为70%~74% 时表现出较好的 流动性能;灰砂比1∶4、质量浓度74%的全尾砂充填料浆的临界流速较实际工作流速小,最大允许 充填倍线为4.69,大于矿山绝大部分采场实际充填倍线;综合判断,矿山全尾砂可以作为充填料浆 骨料。

关键词: 充填开采, 全尾砂料浆, 临界流速, 充填倍线

Abstract: In order to explore the reliability of pipeline gravity conveying of full tailings-filled slurry in a mine,the slump,consistency,stratification,yield stress and plastic viscosity of each ratio of full-tail⁃ ings-filled slurry were tested. The critical flow rate and filling ratio of the recommended ratio of full tailings slurry under the current filling system conditions are calculated. The results show that when the mass con⁃ centration of the slurry is 70%~74%,it exhibits better flow properties. The actual working flow rate of the full tailings filling slurry with a lime-sand ratio of 1:4 and a mass concentration of 74% is more than the critical flow rate,and the filling multiplier in most stopes is less than 4.74. Based on comprehensive judg⁃ ment,the whole mine tailings can be used as filling slurry aggregate.

Key words: backfill mining, full tailings slurry, critical flow rate, filling multiplier