欢迎访问《现代矿业》杂志官方网站,今天是 分享到:
×

扫码分享

现代矿业 ›› 2025, Vol. 41 ›› Issue (09): 79-84.

• 采矿工程 • 上一篇    下一篇

某铅锌矿采空区稳定性分析及治理

孟 华1,2 欧阳志平   

  1. 1. 长沙矿山研究院有限责任公司;2. 金属矿山安全技术国家重点实验室; 3. 中建三局第三建设工程有限责任公司
  • 出版日期:2025-09-25 发布日期:2025-11-04

Stability Analysis and Treatment of a Lead-Zinc Mine Goaf

  1. 1. Changsha Institute of Mining Research Co.,Ltd.;2. State Key Laboratory of Metal Mine Safety Technol⁃ ogy;3. Third Construction Co.,Ltd.,China Construction Third Engineering Bureau
  • Online:2025-09-25 Published:2025-11-04

摘要: 针对某铅锌矿井下大量未设有矿柱的采空区安全隐患大的问题,开展采空区稳定性论 证及治理方案研究。对采空区进行现场调查和室内试验,利用相关理论方法转换确定岩体力学参 数,并运用RQD、RMR及Q系统分级法进行岩体质量综合评价;采用不规则矿柱承载的平均应力计算 仅留有1根矿柱的安全系数,分析其稳定性;结合采空区顶板最大无支护跨度、Mathews稳定图法,按 最不利原则分析顶板的稳定性。结果表明,在 RMR 分级法下的岩体质量结果最差,为 III 级一般岩 体;矿柱安全系数为0.51,远小于安全值1.5;处于较不稳定及以上的空区数量为9个,占总数的60%; 最后对这些空区提出了相应的治理措施,为解决类似空区隐患提供参考。

关键词: Mathews稳定图法, 岩体质量, 采空区, 治理措施

Abstract: Aiming at the problem of great potential safety hazards of a large number of goafs without pillars in a lead-zinc mine,the stability demonstration and treatment scheme of goafs are studied. The field investigation and laboratory test are carried out on the goaf,and the mechanical parameters of rock mass are determined by using the relevant theoretical methods,and the comprehensive evaluation of rock mass quality is carried out by using RQD,RMR and Q system classification method. The safety factor of only one pillar is calculated by using the average stress of irregular pillar bearing,and its stability is ana⁃ lyzed. Combined with the maximum unsupported span of the goaf roof and the Mathews stability diagram method,the stability of the roof is analyzed according to the most unfavorable principle. The results show that the rock mass quality under the RMR classification method is the worst,which is Grade III general rock mass. The safety factor of the pillar is 0.51,which is far less than the safety value of 1.5. The number of unstable and above empty areas is 9,accounting for 60 % of the total. Finally,the corresponding treat⁃ ment measures are put forward for these empty areas,which provides reference for solving similar hidden dangers in empty areas.

Key words: Mathews stability diagram method, rock mass quality, goaf, treatment measure