欢迎访问《现代矿业》杂志官方网站,今天是 分享到:

现代矿业 ›› 2013, Vol. 29 ›› Issue (01): 24-26.

• 采选工程 • 上一篇    下一篇

刘河煤矿采动影响下覆岩破坏高度的相似模拟

夏宇1,2,李新文1   

  1. 1.河南理工大学能源科学与工程学院;2.禹州神火隆瑞矿业有限公司
  • 出版日期:2013-01-15 发布日期:2013-01-24

Similar Material Model Test on the Failure Height of Overburden Rock under the Mining Influence in Liuhe Coal Mine

Xia Yu1,2,Li Xinwen1   

  1. 1.School of Energy Science and Engineering, Henan Polytechnic University;2.Longrui Mining Co., Ltd, Shenhuo Group of Yuzhou
  • Online:2013-01-15 Published:2013-01-24

摘要: 为了确定刘河煤矿13021工作面开采对覆岩破坏高度的影响和防砂煤柱的留设,采用实验室相似材料模拟试验,分析了13021工作面推进过程中,其上覆岩层的破坏高度的动态演化过程。通过对不同剖面的相似模拟发现,在13021工作面一次采全高平均采厚2.7 m,上覆岩层垮落带最大高度为16.1 m,模拟结果对于防砂煤柱的留设具有一定的参考价值。

关键词: 采动影响, 上覆岩层, 放砂煤柱, 相似模拟, 跨落带

Abstract: The similar material model test was used to study the influence law of mining of 13021 working surface of Liuhe Coal Mine to failure height of overburden rock, while the sand-proof pillar was also determined.Dynamic evolution process of the failure height of the overburden rock during mining process of 13021 working surface was analyzed.Through the different section of the similar material model test, the test results indicate that the average thickness of full-seam mining at 13021 working surface is 2.7m, and the maximum height of overlying rock caving zone is 16.1 m.The results of model test have certain of reference value for the establishment of sand-proof pillar.

Key words: Mining influence, Overburden strata, Sand-proof pillar, Model test, Caving zone