多参数耦合条件下矿井火灾数值研究

现代矿业 ›› 2011, Vol. 27 ›› Issue (08): 35-37+43.

多参数耦合条件下矿井火灾数值研究

林龙沅¹，陈海焱¹，颜翠平¹，江涛²

1.西南科技大学环境与资源学院；2.中铁大桥局集团有限公司

出版日期:2011-08-15 发布日期:2011-08-17

Research on the Mine Fire Numerical Simulation under the Condition of Multi-Parameter Coupling

Lin Longyuan¹，Chen Haiyan¹，Yan Cuiping¹，Jiang Tao²

1.School of Environment and Resources,Southwest University of Science and Technology；2. China Railway Major Bridge Engineering Group Co.,Ltd,

Online:2011-08-15 Published:2011-08-17

摘要/Abstract

摘要： 为研究多参数影响条件下矿井火灾的发展规律，采用火灾模拟软件FDS考察了巷道发生火灾时，各参数变化对其通风的影响。结果表明：在火源功率由180 kW增大至1 800 kW时，巷道顶部温度值由45 ℃上升至200 ℃；在不同巷道倾角下的巷道顶部温度平均在75～80 ℃，说明巷道倾角对巷道顶部温度影响很小。随着巷道通风速度由0.5 m/s增大至3 m/s，巷道最大气流速度由4.60 m/s增大至5.15 m/s，上风向巷道速度分布均匀，不易产生回流，下风向巷道速度分布较杂乱，烟气分层被破坏。该研究成果对矿山防火有重要的实际意义。

关键词: 矿井火灾, 数值模拟, FDS, 多参数耦合

Abstract: In order to study the mine fire's development law under the impact of multi-parameter, fire dynamics simulator software (FDS) was adopt to inspect the influence from each parameters changing to the ventilation of laneway when fire happened.The result showed the laneway crown temperature rose from 45 ℃ to 200 ℃ when the fire power increased from 180kW to 1800kW; the laneway crown temperature was from about 75～80 ℃ on average under different dip angles of laneway,which indicated that the impact of the dip angles upon the crown temperature was small. As the laneway ventilation speed increased from 0.5m/s to 3m/s, the laneway maximum air stream velocity increased from 4.60m/s to 515m/s, the distribution of upwind laneway velocity was enven and was difficult to produce circumfluence,however that of the downwind laneway velocity was disorderly and the fume layer was destroyed. This study achievement has the important and practice significance for mine fire prevention.

Key words: Mine fire, Numerical simulation, FDS, Multi-parameter coupling

林龙沅, 陈海焱, 颜翠平, 江涛. 多参数耦合条件下矿井火灾数值研究[J]. 现代矿业, 2011, 27(08): 35-37+43.

LIN Long-Yuan, CHEN Hai-Yan, YAN Cui-Ping, JIANG Tao. Research on the Mine Fire Numerical Simulation under the Condition of Multi-Parameter Coupling[J]. Modern Mining, 2011, 27(08): 35-37+43.

[1]	李成, 李亚春, 蒋宗琪. 大地精煤矿近距离煤层同采面错距和巷道布置研究[J]. 现代矿业, 2020, 36(4): 50-55.
[2]	李二宝, 杨恒, 杨海涛, 李传奇. 爆破漏斗成形规律数值模拟及试验研究[J]. 现代矿业, 2020, 36(4): 59-63.
[3]	黄小忠. 基于FLAC^3D的某预留顶柱安全回采工艺优化分析[J]. 现代矿业, 2020, 36(4): 85-89.
[4]	顾默, 郭晓东. 永定庄矿火成岩侵入巷道支护技术研究[J]. 现代矿业, 2020, 36(4): 188-193.
[5]	杨八九, 程涌, 徐刚, 段鑫. 玉溪大红山铁矿Ⅲ#、Ⅳ#矿体北盘区采场地压控制研究[J]. 现代矿业, 2019, 35(1): 77-82.
[6]	李万涛, 赵凯, 徐成岩, 李红刚. 局部凹陷地形对爆炸地震波传播规律影响的研究[J]. 现代矿业, 2019, 35(09): 56-60.
[7]	张海红. 松软煤层巷道围岩变形特征及控制技术[J]. 现代矿业, 2019, 35(09): 72-74.
[8]	杜伟. 45°倾斜岩层巷道围岩变形破坏的FLAC3D数值模拟研究[J]. 现代矿业, 2019, 35(09): 84-88.
[9]	张俊良. 水力压裂卸压技术在矿井顶板防治中的应用[J]. 现代矿业, 2019, 35(09): 116-117.
[10]	尹裕. 某铜矿破碎矿岩条件下分段空场嗣后充填法的应用实践[J]. 现代矿业, 2019, 35(08): 72-73.
[11]	柴世延, 郭明旭, 昌伟锋. 神角矿采动大巷围岩破坏特征与控制技术[J]. 现代矿业, 2019, 35(08): 194-196.
[12]	张永东, 朱亚威, 张恒. 冲击危险工作面大直径卸压钻孔深度优化[J]. 现代矿业, 2019, 35(08): 199-201.
[13]	胡树军, 张树伟. 孔底间隔装药对台阶爆破地震的影响研究[J]. 现代矿业, 2019, 35(08): 204-205.
[14]	胡贵发. 某铁矿尾矿库主坝体稳定性数值模拟分析[J]. 现代矿业, 2019, 35(08): 218-222.
[15]	陆军. 复采煤层末采煤柱合理留设宽度研究[J]. 现代矿业, 2019, 35(04): 70-73.